Ridge split and implant placement in the mandibular molar region
Ridge split and 4.5 mm fixture placement in ridge width of 4 mm with magentic mallet in lower first molar region
8 contributions
Ridge split and 4.5 mm fixture placement in ridge width of 4 mm with magentic mallet in lower first molar region
Indirect / internal sinus lift with Elevate kit and bone graft Extremely soft bone Remaining bone height was 3 mm and 5 mm
N. P. describes a sinus lift with Elevate on 2–3 mm of residual bone, combining expansion and elevation. When a colleague asks about the protocol, N…
During a one-on-one mentoring session, N. P. uses a hydraulic Gdiff technique at the FIRST upper molar and the Magnetic Mallet at the SECOND upper…
Patel presents an All-on-4 case in very narrow ridges. For the lower arch, Patel reports a full-arch split crest with the Mallet and expanders…
Patel explains the preparation of the interradicular septum with Elevate, the choice of a 5 × 7 mm implant and the use of synthetic octacalcium…
N. P. describes a posterior mandibular split crest using Magnetic Mallet Split instruments followed by expanders. In reply to M. R., N. P. specifies…
No contributions in this section.
Patel distinguishes the presented posterior mandibular D2–D3 case from two other anterior D1 cases. Patel also explains the difference between…