Log in or registerItaliano

Original conversation

Post-extraction implant with crestal sinus lift and stabilization in the interradicular septum

15 messages · In conversation order

Case of post-extraction implant placement with a sinus lift via the crestal approach. The base of the interradicular septum allowed the implant to be stabilized.

Original text · Italian

Caso di impianto post-estrattivo con rialzo di seno per via crestale. La base del setto interradicolare ha consentito la stabilizzazione dell’impianto.

Attachment.

Original text · Italian

Allegato.

Attachment.

Original text · Italian

Allegato.

Attachment.

Original text · Italian

Allegato.

No bone grafting only lift ?

I placed a graft of bovine bone.

With the participants in the Masterclass over the next two days, we will discuss the clinical rationale and instrument sequences for managing these cases.

Original text · Italian

Con i partecipanti alla Masterclass dei prossimi due giorni parleremo dei razionali clinici e delle sequenze di strumenti per gestire questi casi.

Hello sir can you share steps of this procedure

I evaluated the quality of the septum that was not so mineralized. Due to this bone consistency I directly used the 200 tip til the sinus floor. After that I used the 300 point causing the fracture of the floor. I started putting a little square of collagen sponge (just to protect the membrane) and subsequently the granules of bone graft. Finally I inserted the fixture.

Which implant is on the 7?

Original text · Italian

che impianto esul 7?

It is a Neodent GM, diam 6.

Original text · Italian

È un Neodent GM diam 6.

With such a diameter, I imagine you use a drill in the first section (given the difference in diameter even with the largest MM tip). Generally, if you use a drill, to what depth?

Original text · Italian

Con un tale diametro, immagino usi nel primo tratto una fresa (vista la differenza di diametro anche col più grande dei terminali del MM). In linea di massima, se usi una fresa, fino a che profondità?

Actually, the consistency was such that I did not need a drill. Once the central hole had been made, I used the flat head of the 300 instrument around the edge of the circumference to widen it slightly, also bringing up a little bone. The preparation was done by eye so that I could enter with the implant apex (which has a diameter slightly wider than the 300); then screwing in the implant condensed the bone laterally and provided stability.

Original text · Italian

In realtà la consistenza era tale che la fresa non mi è servita. Una volta praticato il foro centrale, ho utilizzato la testa piatta dello strumento 300 sul bordo della circonferenza al fine di allargarlo leggermente tirando su anche un pochino di osso. La preparazione è stata ad occhio, al fine di riuscire ad entrare con l’apice dell’impianto (che ha un diametro poco di largo del 300); poi l’avvitamento dell’impianto ha condensato l’osso lateralmente e dato stabilità.

If, instead, you had found good density in the “entry” cortical bone, would you only have created the entry with the last suitable drill for that implant?

Original text · Italian

Se invece avessi riscontrato una buona densità della corticale "di accesso", avresti solo fatto "l'invito" con l'ultima fresa utile per quell'impianto?

Exactly.

Original text · Italian

Esatto.